Abstract
Equilibrium thermodynamic calculations, coupled to a kinetic model for the dissolution rates of clinker phases, have been used in recent years to predict time-dependent phase assemblages in hydrating cement pastes. We couple this approach to a 3D microstructure model to simulate microstructure development during the hydration of ordinary portland cement pastes. The combined simulation tool uses a collection of growth/dissolution rules to approximate a range of growth modes at material interfaces, including growth by weighted mean curvature and growth by random aggregation. The growth rules are formulated for each type of material interface to capture the kinds of cement paste microstructure changes that are typically observed. We make quantitative comparisons between simulated and observed microstructures for two ordinary portland cements, including bulk phase analyses and two-point correlation functions for various phases. The method is also shown to provide accurate predictions of the heats of hydration and 28 day mortar cube compressive strengths. The method is an attractive alternative to the cement hydration and microstructure model CEMHYD3D because it has a better thermodynamic and kinetic basis and because it is transferable to other cementitious material systems.
Similar content being viewed by others
References
D.P. Bentz: Three-dimensional computer simulation of cement hydration and microstructure development. J. Am. Ceram. Soc. 80, 3 (1997).
D.P. Bentz: CEMHYD3D: A three-dimensional cement hydration and microstructure development modeling package. Version 3.0. NISTIR 7232, U.S. Department of Commerce. Available at http://concrete.nist.gov/monograph (2005).
C-J. Haecker, E.J. Garboczi, J.W. Bullard, R.B. Bohn, Z. Sun, S.P. Shah, and T. Voigt: Modeling the linear elastic properties of portland cement paste. Cem. Concr. Res. 35, 1948 (2005).
D.P. Bentz, O.M. Jensen, A.M. Coats, and F.P. Glasser: Influence of silica fume on diffusivity in cement-based materials. I. Experimental and computer modeling studies on cement pastes. Cem. Concr. Res. 30, 953 (2000).
J.M. Torrents, T.O. Mason, and E.J. Garboczi: Impedance spectra of fiber-reinforced cement-based composites: A modeling approach. Cem. Concr. Res. 30, 585 (2000).
H.M. Jennings: Aqueous solubility relationships for two types of calcium silicate hydrate. J. Am. Ceram. Soc. 69, 618 (1986).
P.W. Brown: Phase equilibria and cement hydration, in Materials Science of Concrete, Vol. I, edited by J. Skalny (American Ceramic Society, Westerville, OH, 1989), pp. 73–93.
L.J. Parrot and D.C. Killoh: Prediction of cement hydration. Br. Ceram. Proc. 35, 41 (1984).
D. Kulik: GEMS-PSI 2.03, PSI, Villigen, Switzerland. Available at http://gems.web.psi.ch/ (2009).
B. Lothenbach and F. Winnefeld: Thermodynamic modelling of the hydration of portland cement. Cem. Concr. Res. 36, 209 (2006).
B. Lothenbach and E. Wieland: A thermodynamic approach to the hydration of sulphate-resisting portland cement. Waste Manage. 26, 706 (2006).
B. Lothenbach, T. Matschei, G. Möschner, and F.P. Glasser: Thermodynamic modelling of the effect of temperature on the hydration and porosity of portland cement. Cem. Concr. Res. 38, 1 (2008).
B. Lothenbach, G. Le Saout, E. Gallucci, and K. Scrivener: Influence of limestone on the hydration of portland cements. Cem. Concr. Res. 38, 848 (2008).
E. Guillon, J. Chen, and G. Chanvillard: Physical and chemical modelling of the hydration kinetics of OPC paste using a semi-analytical approach, in Proceedings of the CONMOD’08 International RILEM Symposium on Concrete Modelling, edited by E. Schlangen and G. De Schutter, RILEM Publication SARL, Bagneux, France, (2008), pp. 165–172.
E. Guillon: Modeling the Influence of Physico-Chemical Equilibria on the Microstructure and Some Residual Mechanical Properties. Ph.D. Thesis, Ecole Normale Supérieure de Cachan, Cachan, France (2004).
D.L. Parkhurst and C.A.J. Appelo: User’s guide to PHREEQC (version 2), A computer program for speciation, batch reaction, one-dimensional transport and inverse geochemical calculations. Water Resources Investigation Report 99–4259, U.S. Geological Survey (1999).
F. Tomosawa: Development of a kinetic model for hydration of cement, in Proceedings of the 10th International Congress on the Chemistry of Cement, Vol. 2, edited by H. Justnes, (1997) p. 2ii051.
A.W. Adamson and A.P. Gast: Physical Chemistry of Surfaces, 6th ed. (Wiley-Interscience, New York, 1997).
M.A.B. Promentilla, T. Sugiyama, T. Hitomi, and N. Takeda: Quantification of tortuosity in hardened cement pastes using synchrotron-based x-ray computed microtomography. Cem. Concr. Res. 39, 548 (2009).
L.M. Schwartz, F. Auzerais, J. Dunsmuir, N. Martys, D.P. Bentz, and S. Torquato: Transport and diffusion in 3-dimensional composite media. Physica A 207, 28 (1994).
Annual Book of ASTM Standards, Vol. 04.01 (American Society for Testing and Materials, West Conshohocken, PA, 2000).
Final report: Portland Cement Proficiency Samples Number 151 and Number 152, Cement and Concrete Reference Laboratory, available at http://www.ccrl.us/ (2004).
Final report: Portland Cement Proficiency Samples Number 167 and Number 168, Cement and Concrete Reference Laboratory, available at http://www.ccrl.us/ (2004).
P.E. Stutzman and J.R. Clifton: Sample preparation for scanning electron microscopy, in Proceedings of the Twenty-First Annual International Conference on Cement Microscopy, edited by L. Jany and A. Nisperos (ICMA, Metropolis, IL, USA, 1999), pp. 10–22.
P. Stutzman: Multi-spectral SEM imaging of cementitious materials, in Proceedings of the Twenty-Ninth Annual Conference on Cement Microscopy, edited by L. Sutter (ICMA, Metropolis, IL, USA, 2007).
D. Landgrebe and L. Biehl: An introduction to Multispec. Available at http://dynamo.ecn.purdue.edu/~biehl/MultiSpec.
D. Landgrebe: Signal Theory Methods in Multispectral Remote Sensing (John Wiley and Sons, Inc, New York, 2003).
D.P. Bentz, P.E. Stutzman, C.J. Haecker, and S. Remond: SEM/x-ray imaging of cement-based materials, in Proceedings of the 7th Euroseminar on Microscopy Applied to Building Materials, edited by H.S. Pietersen, J.A. Larbia, and H.H. A. Janssen (Delft University of Technology, Delft, The Netherlands, 1999), pp. 457–466.
P. Stutzman and S. Leigh: Phase analysis of hydraulic cements by x-ray powder diffraction: Precision, bias, and qualification. J. ASTM Int. 4, 5 (2007).
L.E. Copeland and R.H. Bragg: Quantitative x-ray diffraction analysis. Anal. Chem. 30, 196 (1958).
P. Seligmann and N.R. Greening: Studies of early hydration reactions of portland cement by x-ray diffraction. Highway Research Record No. 62, 80–105 (1964).
K.L. Scrivener, T. Füllman, E. Gallucci, G. Walenta, and E. Bermejo: Quantitative study of portland cement hydration by x-ray diffration/Rietveld analysis and independent methods. Cem. Concr. Res. 34, 1541 (2004).
A.E. Moore and H.F.W. Taylor: The crystal structure of ettringite. Acta Crystallogr., Sect B 26, 386 (1970).
R. Allmann: Refinement of the hybrid layer structure of Ca2[Al(OH)6]+[1/2SO4 3H2O]. Neues Jahrb. Mineral. Monatsh. 3, 136 (1977).
D.M. Henderson and H.S. Gutowsky: A nuclear magnetic resonance determination of the hydrogen positions in Ca(OH)2. Am. Mineral. 47, 1231 (1962).
H.F.W. Taylor: Cement Chemistry, 2nd ed. (Thomas Telford, London, 1997).
X. Cong and R.J. Kirkpatrick: 29Si MAS NMR study of the structure of calcium silicate hydrate. Adv. Cem. Based Mater. 3, 144 (1996).
I.G. Richardson: Tobermorite/jennite- and tobermorite/calcium hydroxide-based models for the structure of C–S–H: Applicability to hardened pastes of tricalcium silicate, β-dicalcium silicate, portland cement, and blends of portland cement with blast-furnace slag, metakaolin, or silica fume. Cem. Concr. Res. 34, 1733 (2004).
E. Bonaccorsi, S. Merlino, and A.R. Kampf: The crystal structure of tobermorite 14 Å (plombierite), a C–S–H phase. J. Am. Ceram. Soc. 88, 505 (2005).
W. Hummel, U. Berner, E. Curti, F.J. Pearson, and T. Thoenen: Nagra/PSI Chemical Thermodynamic Data Base 01/01 (Universal Publishers, Wettingen, Switzerland, 2002).
T. Matschei, B. Lothenbach, and F.P. Glasser: Thermodynamic properties of portland cement hydrates in the system CaO-Al2O3-SiO2-CaSO4-CaCO3-H2O. Cem. Concr. Res. 37, 1379 (2007).
D.A. Kulik and M. Kersten: Aqueous solubility diagrams for cementitious waste stabilization systems: II. End-member stoichiometries of ideal calcium silicate hydrate solid solutions. J. Am. Ceram. Soc. 84, 3017 (2001).
J.W. Bullard and P.E. Stutzman: Analysis of CCRL proficiency cements 151 and 152 using the virtual cement and concrete testing laboratory. Cem. Concr. Res. 36, 1548 (2006).
E.J. Garboczi and J.W. Bullard: Shape analysis of a reference cement. Cem. Concr. Res. 34, 1933 (2004).
J.W. Bullard and E.J. Garboczi: A model investigation of the influence of particle shape on portland cement hydration. Cem. Concr. Res. 36, 1007 (2006).
D. Kaschiev and G.M. van Rosmalen: Review: Nucleation in solutions revisited. Cryst. Res. Technol. 38, 555 (2003).
J.G. Berryman and S.C. Blair: Use of digital image analysis to estimate fluid permeability of porous materials: Application of two-point correlation functions. J. Appl. Phys. 60, 1930 (1986).
E.J. Garboczi, D.P. Bentz, and N.S. Martys: Digital images and computer modeling, in Experimental Methods for Porous Media, edited by P. Wong (Academic Press, New York, 1999).
A.J. Allen, J.J. Thomas, and H.M. Jennings: Composition and density of nanoscale calcium-silicate-hydrate in cement. Nat. Mater. 6, 311 (2007).
H.M. Jennings: A model for the microstructure of calcium silicate hydrate in cement paste. Cem. Concr. Res. 30, 101 (2000).
Acknowledgments
This work was supported by the United States Department of Energy Cementitious Barriers Partnership program and by the Sustainable Concrete Materials program at NIST.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
About this article
Cite this article
Bullard, J.W., Lothenbach, B., Stutzman, P.E. et al. Coupling thermodynamics and digital image models to simulate hydration and microstructure development of portland cement pastes. Journal of Materials Research 26, 609–622 (2011). https://doi.org/10.1557/jmr.2010.41
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/jmr.2010.41