Abstract
Substrate effects on the measurement of thin film mechanical properties by nanoindentation methods have been studied experimentally using a model soft film on hard substrate system: aluminum on glass. The hardness and elastic modulus of aluminum films with thicknesses of 240, 650, and 1700 nm sputter-deposited on glass were systematically characterized as a function of indenter penetration depth using standard nanoindentation methods. Scanning electron and atomic force microscopy of the hardness impressions revealed that indentation pileup in the aluminum is significantly enhanced by the substrate. The substrate also affects the form of the unloading curve in a manner that has important implications for nanoindentation data analysis procedures. Because of these effects, nanoindentation measurement techniques overestimate the film hardness and elastic modulus by as much as 100% and 50%, respectively, depending on the indentation depth. The largest errors occur at depths approximately equal to the film thickness.
This is a preview of subscription content, log in via an institution to check access.
Similar content being viewed by others
References
T.Y. Tsui, W. C. Oliver, and G.M. Pharr, in Thin Films: Stresses and Mechanical Properties VI, edited by W.W. Gerberich, H. Gao, J-E. Sundgren, and S. P. Baker (Mater. Res. Soc. Symp. Proc. 436, Pittsburgh, PA, 1997), p. 207.
W. C. Oliver, C. J. McHargue, and S. J. Zinkle, Thin Sol. Films 153, 185 (1987).
W. C. Oliver and C. J. McHargue, Thin Sol. Films 161, 117 (1988).
W. C. Oliver, R. Hutchings, and J. B. Pethica, in Microindentation Techniques in Materials Science and Engineering, edited by P. J. Blau and B. R. Lawn (American Society for Testing and Materials, Philadelphia, PA, 1986), pp. 90–108.
S. M. Gorbatkin, R. L. Rhodes, T. Y. Tsui, and W.C. Oliver, Appl. Phys. Lett. 65, 2672 (1994).
B. D. Fabes and W. C. Oliver, in Thin Films: Stresses and Mechanical Properties II, edited by M. Doerner, W. C. Oliver, G. M. Pharr, and F. R. Brotzen (Mater. Res. Soc. Symp. Proc. 188, Pittsburgh, PA, 1990), p. 127.
M. F. Doerner, D. S. Gardner, and W. D. Nix, J. Mater. Res. 1, 845 (1986).
M. F. Doerner and W. D. Nix, J. Mater. Res. 1, 601 (1986).
W. C. Oliver and G. M. Pharr, J. Mater. Res. 7, 1564 (1992).
G. M. Pharr and W. C. Oliver, MRS Bulletin 17, 28 (1992).
J. L. Loubet, J. M. Georges, O. Marchesini, and G. Meille, J. Tribology 106, 43 (1984).
J. B. Pethica, R. Hutchings, and W. C. Oliver, Philos. Mag. A 48, 593 (1983).
A. K. Bhattacharya and W. D. Nix, Int. J. Solids Struct. 24, 1287 (1988).
T. A. Laursen and J. C. Simo, J. Mater. Res. 7, 618 (1992).
T. Y. Tsui, W. C. Oliver, and G. M. Pharr, J. Mater. Res. 11, 752 (1996).
A. Bolshakov, W.C. Oliver, and G. M. Pharr, J. Mater. Res. 11, 760 (1996).
A. Bolshakov, W. C. Oliver, and G. M. Pharr, in Thin Films: Stresses and Mechanical Properties VI, edited by W.W. Gerberich, H. Gao, J-E. Sundgren, and S. P. Baker (Mater. Res. Soc. Symp. Proc. 436, Pittsburgh, PA, 1997), p. 760.
A. Bolshakov and G. M. Pharr, J. Mater. Res. 13, 1049 (1998).
R. B. King, Int. J. Solids Struct. 23, 1657 (1987).
H. Gao, C-H. Chiu, and J. Lee, Int. J. Solids Struct. 29, 2471 (1992).
D. Stone, W.R. LaFontaine, P. Alexopoulos, T. W. Wu, and C-Y. Li, J. Mater. Res. 3, 141 (1988).
T.Y. Tsui, Ph.D. Dissertation, Rice University, July 1996.
D. Tabor, The Hardness of Metals (Oxford University Press, London, 1951).
A. F. Bower, N. Fleck, A. Needleman, and N. Ogbonna, Proc. R. Soc. Lond. A 441, 97 (1993).
G. M. Pharr, A. Bolshakov, T. Y. Tsui, and J. C. Hay, Mater. Res. Soc. Symp. Proc., in press.
Author information
Authors and Affiliations
Rights and permissions
About this article
Cite this article
Tsui, T.Y., Pharr, G.M. Substrate effects on nanoindentation mechanical property measurement of soft films on hard substrates. Journal of Materials Research 14, 292–301 (1999). https://doi.org/10.1557/JMR.1999.0042
Received:
Accepted:
Published:
Issue Date:
DOI: https://doi.org/10.1557/JMR.1999.0042