Skip to main content
Log in

Physical properties of spinel iron oxide thin films

  • Articles
  • Published:
Journal of Materials Research Aims and scope Submit manuscript

Abstract

This paper describes the complexity of the spinel iron oxides in thin-film configuration. First, the experimental deposition conditions are determined for the parameters of substrate temperature and oxygen flow such that only the “Fe3O4” phase is formed. Then a study is made of how the structural (grain size, lattice parameter, texture), magnetic (M), and optical (visible and infrared transmission) properties of the films depend on the deposition and postdeposition (air annealing) conditions. The experimental deposition region is defined where the films have the most similar physical properties to bulk Fe3O4 and subsequently, after annealing, to bulk gamma Fe2O3. Finally, a discussion is presented of a model that accounts for the anomalous, low values of the magnetic moment for the samples deposited at room temperature. The model proposes an overpopulation of the iron tetrahedral A sites.

This is a preview of subscription content, log in via an institution to check access.

Access this article

Price excludes VAT (USA)
Tax calculation will be finalised during checkout.

Instant access to the full article PDF.

Similar content being viewed by others

References

  1. H. Boppart, A. Schlegel, and P. Wachter, Philos. Mag. B 42, 431 (1980).

    Article  Google Scholar 

  2. P. S. Sidhu, R. T. Gilkes, and A. M. Posner, J. Inorg. Nucl. Chem. 39, 1953 (1977).

    Article  CAS  Google Scholar 

  3. H. Ouchi and M. Umesaki, IEEE Trans. Mag. 19, 1980 (1983).

    Article  Google Scholar 

  4. M. M. Chen, C. Ortiz, G. Lin, R. Sigsbee, and G. Castillo, IEEE Trans. Mag. 23, 3423 (1987).

    Article  Google Scholar 

  5. M. Hansen, Constitution of Binary Alloys (McGraw-Hill, New York, 1958), p. 684.

    Google Scholar 

  6. R. Messier and R. Roy, J. Non-Cryst. Solids 98, 107 (1978).

    Article  Google Scholar 

  7. Joint Committee on Powder Diffraction Standards, International Center for Diffraction Data, Swarthmore, PA 19081.

  8. S. Ohta, A. Terada, Y. Ishi, and S. Hattou, Trans. IECE Jpn. E68, 173 (1985).

    Google Scholar 

  9. S. S. P. Parkin, R. Sigsbee, R. Felici, and G. P. Felcher, Appl. Phys. Lett. 48, 604 (1986).

    Article  CAS  Google Scholar 

  10. C. J. Serna, J. L. Rendon, and J. E. Iglesias, Spectrochim. Acta 38A, 797 (1982).

    Article  CAS  Google Scholar 

  11. S. Onari, T. Arai, and K. Kudo, Phys. Rev. B 16, 1717 (1977).

    Article  Google Scholar 

  12. C. Ortiz, G. Vurens, M. M. Chen, and M. Salmeron (to be published).

  13. V. S. Speriosu (private communication).

  14. S. M. Aharoni and M. H. Litt, J. Appl. Phys. 42, 352 (1970).

    Article  Google Scholar 

  15. J. M. D. Coey and D. Khalafalla, Phys. Status Solidi 11, 229 (1972).

    Article  CAS  Google Scholar 

Download references

Author information

Authors and Affiliations

Authors

Rights and permissions

Reprints and permissions

About this article

Cite this article

Ortiz, C., Lim, G., Chen, M.M. et al. Physical properties of spinel iron oxide thin films. Journal of Materials Research 3, 344–350 (1988). https://doi.org/10.1557/JMR.1988.0344

Download citation

  • Received:

  • Accepted:

  • Published:

  • Issue Date:

  • DOI: https://doi.org/10.1557/JMR.1988.0344

Navigation