Hostname: page-component-7c8c6479df-24hb2 Total loading time: 0 Render date: 2024-03-29T00:35:39.185Z Has data issue: false hasContentIssue false

Mg Doped GaN Using a Valved, Thermally Energetic Source: Enhanced Incorporation, Control and Quantitative Optimization

Published online by Cambridge University Press:  01 February 2011

Shawn D. Burnham
Affiliation:
Electrical and Computer Engineering, Georgia Institute of Technology, Atlanta, GA 30332
W. Alan Doolittle
Affiliation:
Electrical and Computer Engineering, Georgia Institute of Technology, Atlanta, GA 30332
Gon Namkoong
Affiliation:
Electrical and Computer Engineering, Georgia Institute of Technology, Atlanta, GA 30332
Walter Henderson
Affiliation:
Electrical and Computer Engineering, Georgia Institute of Technology, Atlanta, GA 30332
Get access

Abstract

In this study, a thermally-energetic Mg source with an independent, valved-flux control was used to study the behavior of Mg incorporation into GaN. To observe effects of the thermal energy of the Mg flux on Mg incorporation, two Mg flux temperatures were investigated: one (900°C) well above the melting point of Mg and one (625°C) slightly below the melting point of Mg. Alternating Mg-doped and undoped GaN layers were grown at steps of increasing Mg flux, retaining a constant thermal energy, from below the saturation limit, to above the saturation limit. Results were analyzed and compared using secondary ion mass spectroscopy (SIMS). For a constant measured Mg flux, the incorporated Mg increased by more than an order of magnitude when the Mg thermal source temperature was raised from 625°C to 900°C. During SIMS analysis, the energy spectra of sputtered Ga atoms were fairly constant for a Mg flux above the saturation limit, and shifts for a Mg flux slightly below the critical flux for saturation, indicating a conductivity change, and possibly providing a quantitative means of optimizing p-type conduction. Furthermore, Mg incorporation into GaN strongly depends on the III-V flux ratio. During this study it was also observed that Mg incorporation into GaN was enhanced on a rough growth-layer surface under N-rich conditions, while a smoother growth-layer surface resulted in lower Mg incorporation, even under N-rich conditions1.

Type
Research Article
Copyright
Copyright © Materials Research Society 2004

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Berishev, I., Kim, E., Fartassi, A. et al., J. Vac. Sci. and Tech. 14 (4), 2166 (1999).Google Scholar
2 Amano, H., Sawaki, N., Akasaki, I. et al., Applied Physics Letters 48 (5), 353 (1986).Google Scholar
3 Lide, David R., CRC Handbook of Chemistry and Physics, 78 ed. (CRC Press, Boca Raton, 1997).Google Scholar
4 Ptak, A. J., Myers, T. H., Romano, L. T. et al., Applied Physics Letters 78 (3), 285 (2001).Google Scholar
5 Van De Walle, Chris G., Stampfl, C., and Neugebauer, J., J. Cryst. Growth 189–190, 505 (1998).Google Scholar
6 Akasaki, Isamu, Amano, Hiroshi, Kito, Masahiro et al., J. Luminescence 48–49 (2), 666 (1991).Google Scholar
7 Namkoong, Gon, Alan Doolittle, W., Brown, April S. et al., J. Cryst. Growth 252 (1–3), 159 (2003).Google Scholar
8 Thomas, E. W. and Torabi, A., Nuc. Instr. & Meth. Phys. Res., Sect. B B73 (2), 214 (1993).Google Scholar
9 Namkoong, Gon, Alan Doolittle, W., and Brown, April S., Appl. Phys. Lett. 77 (26), 4386 (2000).Google Scholar
10 http://www.eeel.nist.gov/812/hall.html, (National Institute of Standards and Technology, 2002).Google Scholar