Hostname: page-component-8448b6f56d-dnltx Total loading time: 0 Render date: 2024-04-15T10:35:37.831Z Has data issue: false hasContentIssue false

Particle–wall collisions in a viscous fluid

Published online by Cambridge University Press:  22 June 2001

G. G. JOSEPH
Affiliation:
Division of Engineering and Applied Sciences, California Institute of Technology, Pasadena, CA 91125, USA
R. ZENIT
Affiliation:
Instituto de Investigaciones en Materiales, Universidad Nacional Autónoma de México, México D.F. 04510, México
M. L. HUNT
Affiliation:
Division of Engineering and Applied Sciences, California Institute of Technology, Pasadena, CA 91125, USA
A. M. ROSENWINKEL
Affiliation:
Division of Engineering and Applied Sciences, California Institute of Technology, Pasadena, CA 91125, USA

Abstract

This paper presents experimental measurements of the approach and rebound of a particle colliding with a wall in a viscous fluid. The particle's trajectory was controlled by setting the initial inclination angle of a pendulum immersed in a fluid. The resulting collisions were monitored using a high-speed video camera. The diameters of the particles ranged from 3 to 12 mm, and the ratio of the particle density to fluid density varied from 1.2 to 7.8. The experiments were performed using a thick glass or Lucite wall with different mixtures of glycerol and water. With these parameters, the Reynolds number defined using the velocity just prior to impact ranged from 10 to approximately 3000. A coefficient of restitution was defined from the ratio of the velocity just prior to and after impact.

The experiments clearly demonstrate that the rebound velocity depends on the impact Stokes number (defined from the Reynolds number and the density ratio) and weakly on the elastic properties of the material. Below a Stokes number of approximately 10, no rebound of the particle occurred. For impact Stokes number above 500 the coefficient of restitution appears to asymptote to the values for dry collisions. The coefficients of restitution were also compared with previous experimental studies. In addition, the approach of the particle to the wall indicated that the particle slowed prior to impacting the surface. The distance at which the particle's trajectory varied due to the presence of the wall was dependent on the impact Stokes number. The particle surface roughness was found to affect the repeatability of some measurements, especially for low impact velocities.

Type
Research Article
Copyright
© 2001 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)