Hostname: page-component-8448b6f56d-m8qmq Total loading time: 0 Render date: 2024-04-17T13:39:50.267Z Has data issue: false hasContentIssue false
  • English
  • Français

An experimental and numerical study of the Dean problem: flow development towards two-dimensional multiple solutions

Published online by Cambridge University Press:  26 April 2006

B. Bara ,
K. Nandakumar  and
J. H. Masliyah
B. Bara
Affiliation:
Department of Mechanical Engineering, University of Alberta, Edmonton, Alberta, Canada T6G 2G8
K. Nandakumar
Affiliation:
Department of Chemical Engineering, University of Alberta, Edmonton, Alberta, Canada T6G 2G6
J. H. Masliyah
Affiliation:
Department of Chemical Engineering, University of Alberta, Edmonton, Alberta, Canada T6G 2G6
Get access Rights & Permissions [Opens in a new window]

Abstract

An experimental and numerical study investigating the flow development and fully developed flows of an incompressible Newtonian fluid in a curved duct of square cross section with a curvature ratio of 15.1 is presented. Numerical simulations of flow development from a specified inlet profile were performed using a parabolized form of the steady three-dimensional Navier-Stokes equations. No symmetry conditions were imposed. In general there was good agreement between the numerical predictions of the developing axial velocity profiles and LDV measurements. In addition, for computational expediency, the two-dimensional solution structure was calculated by imposing fully developed conditions together with symmetry conditions along the horizontal duct centreline.

Laser-Doppler measurements of axial velocity and flow visualization at Dean number Dn = 125, 137 and 150, revealed a steady and symmetric two-vortex flow at Dn = 125, and a steady and symmetric four-vortex flow at both Dn = 137 and 150 (Dn = Re/(R/a)½, where Re is the Reynolds number, R is the radius of curvature of the duct and a is the duct dimension). Axial velocity measurements showed that the four-vortex flow at Dn = 150 developed to the solution predicted by the two-dimensional numerical simulation. However, the four-vortex flow at Dn = 137 was still developing when the flow had reached the end of the 240° axial length of the duct. A numerical investigation for Dean numbers in the range of 50 to 175 revealed that at the limit point of the two-cell to four-cell transition the development length appeared to be infinite, and thereafter decreased for increasing Dean numbers. The behaviour of decreasing development length of the four-vortex flow with increasing Dean number has not been reported previously.

Using a symmetrically positioned pin at θ = 5° to induce the four-cell flows, the two-dimensional solution structure for Dn [les ] 150 was experimentally observed for the first time. Experiments were consistent with the prediction by Winters (1987) that four-vortex flows are stable to symmetric perturbations, but unstable to asymmetric perturbations. Experimental and numerical investigations suggested that, when perturbed asymmetrically, the four-vortex flow might evolve to flows with sustained spatial oscillations farther downstream.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 244 , November 1992 , pp. 339 - 376
Copyright
© 1992 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Agrawal Y., Talbot, L. & Gong K. 1978 Laser anemometer study of flow development in curved circular pipes. J. Fluid Mech. 85, 497–518.Google Scholar
Akiyama M. 1969 Laminar forced convection heat transfer in curved rectangular channels. M.Sc. thesis, Mechanical Engineering Department, University of Alberta.
Austin, L. R. & Seader J. D. 1974 Entry region for steady viscous flow in coiled circular pipes. AIChE J. 20, 820–822.Google Scholar
Bara B. 1991 Experimental Investigation of developing and fully developed flow in a curved duct of square cross section. Ph.D. thesis, Mechanical Engineering Department, University of Alberta.
Beavers G. S., Sparrow, E. M. & Magnuson R. A. 1970 Experiments on hydrodynamically developing flow in rectangular ducts of arbitrary aspect ratio. Intl J. Heat Mass Transfer 13, 689–702.Google Scholar
Benjamin T. B. 1978a Bifurcation phenomena in steady flows of a viscous fluid. I. Theory. Proc. B. Soc. Lond. A. 359, 1–26.Google Scholar
Benjamin T. B. 1978b Bifurcation phenomena in steady flows of a viscous fluid. II. Experiments. Proc. R. Soc. Lond. A. 359, 27–43.Google Scholar
Berger S. A., Talbot, L. & Yao L.-S. 1983 Flow in curved pipes. Ann. Rev. Fluid Mech. 15, 461–512.Google Scholar
Campbell R. 1991 Image processing techniques for analysis of full color turbulent jet images. M.Sc. thesis, Mechanical Engineering Department, University of Alberta.
Cheng, K. C. & Akiyama M. 1970 Laminar forced convection heat transfer in curved rectangular channels. Intl J. Heat Mass Transfer 13, 471–490.Google Scholar
Cheng K. C. Lin, R-C. & Ou, J-W. 1975 Graetz problem in curved square channels. Trans. ASME C: J. Heat Transfer 97, 244–248.Google Scholar
Cheng K. C., Lin, R-C. & Ou J-W. 1976 Fully developed laminar flow in curved rectangular channels. Trans. ASME C: J. Fluids Engng. 98, 41–48.Google Scholar
Cheng K. C., Nakayama, J. & Akiyama M. 1979 Effect of finite and infinite aspect ratios on flow patterns in curved rectangular channels. In Flow Visualization, pp. 181–186. Hemisphere.
Cheng, K. C. & Yeun F. P. 1987 Flow visualization studies on secondary flow patterns in straight tubes downstream of a 180 deg bend and in isothermally heated horizontal tubes. Trans. ASME C: J. Heat Transfer 109, 49–54.Google Scholar
Cuming H. G. 1952 The secondary flow in curved pipes. Aeronaut. Res. Counc. Rep. Mem., No. 2880.Google Scholar
Daskopoulos, P. & Lenhoff A. M. 1989 Flow in curved ducts: bifurcation structure for stationary ducts. J. Fluid Mech. 203, 125–148.Google Scholar
Dean W. R. 1927 Note on the motion of fluid in a curved pipe Phil. Mag. (7) 4, 208–223.Google Scholar
Dean W. R. 1928a The stream-line motion of fluid in a curved pipe Phil. Mag. (7) 5, 673–695.Google Scholar
Dean W. R. 1928b Fluid motion in a curved channel Proc. R. Soc. Lond. A 121, 402–420.Google Scholar
Dennis, S. R. C. & Ng M. 1982 Dual solutions for steady laminar flow through a curved tube. Q. J. Mech. Appl. Maths 35, 305–324.Google Scholar
Eustice J. 1910 Flow of water in curved pipes Proc. R. Soc. Lond. A 84, 107–118.Google Scholar
Eustice J. 1911 Experiments on stream-life motion in curved pipes Proc. R. Soc. Lond. A 85, 119–131.Google Scholar
Eustice J. 1925 Flow of fluids in curved passages. Engineering Nov. 13, pp. 604–605.Google Scholar
Finlay W. H., Keller, J. B. & Ferziger J. H. 1988 Instability and transition in curved channel flow. J. Fluid Mech. 194, 417–456.Google Scholar
Ghia, K. N. & Sokhey J. S. 1977 Laminar incompressible viscous flow in curved ducts of regular cross-section. Trans. ASME I: J. Fluids Engineering 99, 640–648.Google Scholar
Goldstein, R. J. & Kreid D. K. 1967 Measurement of laminar flow development in a square duct using a laser-doppler flowmeter. Trans. ASME E: J. Appl. Mech. 34, 813–818.Google Scholar
Hille P., Vehrenkamp, R. & Schulz-Dubois E. O. 1985 The development and structure of primary and secondary flow in a curved square duct. J. Fluid Mech. 151, 219–241.Google Scholar
Humphrey J. A. C., Taylor, A. M. K. & Whitelaw J. H. 1977 Laminar flow in a square duct of strong curvature. J. Fluid Mech. 83, 509–527.Google Scholar
Ito H. 1951 Theory on laminar flow through curved pipes of elliptic and rectangular cross-sections. Rep. Inst. High Speed Mech., Tohoku Univ., Sendai Japan, vol. 1. pp. 1–16.Google Scholar
Ito H. 1987 Flow in curved pipes. JSME Int. J. 30, 543–552.Google Scholar
Joseph B., Smith, E. P. & Alder R. J. 1975 Numerical treatment of laminar flow in helically coiled tubes of square cross section. Part 1. Stationary helically coiled tubes. AIChE J. 21, 965–974.Google Scholar
Kajishima T., Miyake, Y. & Inaba T. 1989 Numerical simulation of laminar flow in curved ducts of rectangular cross section. JSME Intl J. 32, 516–522.Google Scholar
Koga D. J., Abrahamson, S. D. & Eaton J. K. 1987 Development of a portable laser sheet. Expts. Fluids 5, 215–216.Google Scholar
Masliyah J. H. 1980 On laminar flow in curved semicircular ducts. J. Fluid Mech. 99, 469–479.Google Scholar
Nandakumar, K. & Masliyah J. H. 1982 Bifurcation in steady laminar flow through curved tubes. J. Fluid Mech. 119, 475–490.Google Scholar
Nandakumar, K. & Masliyah J. H. 1986 Swirling flow and heat transfer in coiled and twisted pipes. Advances in Transport Processes, vol. 4, pp. 49–112. Wiley Eastern.
Nandakumar K., Raszillier, H. & Durst F. 1991 Flow through rotating rectangular ducts Phys. Fluids A 3, 770–781.Google Scholar
Nandakumar, K. & Weinitschke H. J. 1991 A bifurcation study of mixed convection heat transfer in horizontal ducts. J. Fluid Mech. 231, 157–187.Google Scholar
Patankar S. V. 1980 Numerical Heat Transfer and Fluid Flow. Hemisphere.
Sankar S. R., Nandakumar, K. & Masliyah J. H. 1988 Oscillatory flows in coiled square ducts. Phys. Fluids 31, 1348–1358.Google Scholar
Schlichting H. 1979 Boundary-Layer Theory (7th edn). McGraw-Hill.
Shah, R. K. & London A. L. 1978 Laminar Flow Forced Convection in Ducts. Academic.
Shanthini W. 1985 Bifurcation phenomena of generalized newtonian fluids in curved rectangular ducts. M.Sc. thesis, Chemical Engineering Department, University of Alberta.
Shanthini, W. & Nandakumar K. 1986 Bifurcation phenomena of generalized newtonian fluids in curved rectangular ducts. J. Non-Newtonian Fluid Mech. 22, 35–60.Google Scholar
Soh W. Y. 1988 Developing fluid flow in a curved duct of square cross-section and its fully developed dual solutions. J. Fluid Mech. 188, 337–361.Google Scholar
Sugiyama S., Hayashi, T. & Yamazaki K. 1983 Flow characteristics in the curved rectangular channels (visualization of secondary flow) Bull. JSME 26, 964–969.Google Scholar
Sugiyama S., Aoi T., Yamamoto, M. & Narisawa N. 1989 Measurements of developing laminar flow in a curved rectangular duct by means of LDV. In Experimental Heat Transfer, Fluid Mechanics and Thermodynamics, (ed. R. K. Shah et al.), pp. 1185–1191. Elsevier.
Taylor A. M. K. P., Whitelaw, J. H. & Yianneskis M. 1982 Curved ducts with strong secondary motion: velocity measurements of developing laminar and turbulent flow. Trans. ASME I: J. Fluids Engng. 104, 350–359.Google Scholar
Thomson J. 1876 On the origin windings of rivers in alluvial plains, with remarks on the flow of water round bends in pipes Proc. R. Soc. Lond. A 25, 5–8.Google Scholar
Weinitschke H. J., Nandakumar, K. & Sankar S. R. 1990 A bifurcation study of convective heat transfer in porous media Phys. Fluids A 2, 912–921.Google Scholar
Williams G. S., Hubbell, C. W. & Finkell G. H. 1902 Experiments at Detroit, Michigan on the effect of curvature on the flow of water in pipes. Trans. ASCE 47, 1–196.Google Scholar
Winters K. H. 1987 A bifurcation study of laminar flow in a curved tube of rectangular cross-section. J. Fluid. Mech. 180, 343–369.Google Scholar
Winters, K. H. & Brindley R. C. G. 1984 19 Multiple solutions for laminar flow in helically-coiled tubes AERE Rep. 11373. AERE Harwell, UK.
Yanase S., Goto, N. & Yamamoto K. 1988 Stability of dual solutions of the flow in a curved circular tube. J. Phys. Soc. Japan 57, 2602–2604.Google Scholar
Yang, Z.-H. & Keller H. B. 1986 Multiple laminar flows through curved pipes. Appl. Numer. Maths 2, 257–271.Google Scholar
Yao, L.-S. & Berger S. A. 1988 The three-dimensional boundary layer in the entry region of curved pipes with finite curvature ratio. Phys. Fluids 31, 486–494.Google Scholar
Yarborough J. M. 1974 Cw dye laser emission spanning the visible spectrum. Appl. Phys. Lett. 24, 629–630.Google Scholar
Yee G., Chilukuri, R. & Humphrey J. A. C. 1980 Developing flow and heat transfer in strongly curved ducts of rectangular cross section. Trans. ASME C: J. Heat Transfer 102, 285–291.Google Scholar